Rockwell-automation 1760-xxxx Pico GFX-70 Controllers User Manual Manual do Utilizador descarregar pdf (Página 98)

Publication 1760-UM002B-EN-P - March 2005

3-20 Commissioning

Configuring the Connection

for the Terminal Mode

If you wish to set up point-to-point communication with another station, this

can be done using either the serial interface or the Pico-Link. The GFX must

be provided with a display and keypad. The connection must be configured for

this purpose (see also: Introduction to the Serial Interface on page 6-16).

Proceed as follows:

1. Connect both stations together.

Only use original connection cables. The connector marked POW-Side

must be plugged into a GFX. The GFX feeds the interface electronics

of the connection line at both ends.

2. Connect both stations to the power supply.

Figure 3.11 Serial connection example with two stations

The GFX is the active station and the second station is the remote

station.

3. Switch on the power supply at both stations.

IMPORTANT

Ensure that the other station supports the Serial

Interface mode.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 399 400

Comentários a estes Manuais

Sem comentários