Rockwell-automation MPMA Integrated Multi-Axis Linear Stages Manual do Utilizador descarregar pdf (Página 111)

Rockwell Automation Publication MPMA-UM001B-EN-P - November 2010 111

Appendix

Interconnect Diagrams

Introduction

This appendix provides wiring examples to assist you in wiring an MPAS linear

stage to a Allen-Bradley drive.

Wiring Examples

The notes below apply to the wiring examples on the pages that follow.

Not all of the notes apply to each example.

Topic Page

Wiring Examples

111

Motor/Axis Module Wiring Examples 112

Note Information

1 Cable shield clamp must be used in order to meet CE requirements. No external connection to ground is required.

2 The Kinetix 2000 or Kinetix 6000 axis module referenced is either an individual axis module or the same axis module that resides within an

multi-axis system.

3 For motor cable specifications, refer to the Kinetix Motion Control Selection Guide, publication GMC-SG001

4 MPAS-Axxxxxx encoders use the +5V dc supply. MPAS-Bxxxxxx encoders use +9V dc.

5 Use a flyback diode for noise suppression of the motor brake coil of an Ultra3000 drive. For more information, refer to System Design for

Control of Electrical Noise, publication GMC-RM001.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 135 136

Sem comentários

Rockwell-automation MPMA Integrated Multi-Axis Linear Stages Manual do Utilizador Página 111