Rockwell-automation IASIMP Computer Numerical Control (CNC) Machining Manual do Utilizador descarregar pdf (Página 47)

Rockwell Automation Publication IASIMP-QS034A-EN-P - October 2012 47

Chapter

FANUC CNC Configuration

In this chapter you initially configure your FANUC 30i-B, 31i-B, 32i-B, or 35i-B CNC, set up the CNC

communication, and create a new project file for your CNC application. The intent is to provide a quick setup

for an EtherNet/IP connection between a Rockwell Automation ControlLogix/GuardLogix PLC and a

FANUC 30i-B, 31i-B, 32i-B, or 35i-B CNC.

The overall CNC configuration and parameterization is not being addressed by this quick start, and is the

responsibility of the machine tool builder.

Before You Begin

• Complete your system architecture and hardware selection (refer to Chapter 1).

• Complete your system layout and wiring (refer to Chapter 2).

What You Need

• The CNC Machining Accelerator Toolkit DVD, publication IASIMP-SP018. For a copy of the DVD,

contact your local Rockwell Automation distributor or sales representative

• FANUC LADDER III software, version 6.8 or later

• USB flash drive

• FANUC Series 30i/31i/32i/35i –MODEL B, EtherNet/IP Adapter function, publication

• FANUC Series 30i/31i/32i/35i -MODEL B, FANUC Power Motion i -MODEL A EtherNet/IP Scanner

function, publication TMN11095E_B[email protected]

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 277 278

Sem comentários

Rockwell-automation IASIMP Computer Numerical Control (CNC) Machining Manual do Utilizador Página 47