Rockwell-automation IASIMP Computer Numerical Control (CNC) Machining Manual do Utilizador descarregar pdf (Página 183)

Rockwell Automation Publication IASIMP-QS034A-EN-P - October 2012 183

FactoryTalk View ME Configuration Chapter 5

12. Create the expression as shown.

Replace CNCName_FP with the

actual name of the CNC as defined in

your PLC program for the CNC that

this Goto display button represents.

For the CNC Work Cell application

example, the first CNC is the Drilling

CNC, so the CNCName_FP was

replaced with Drill_CNC_FP.

This expression gets the state of the

CNC, and displays it directly on the

Goto button, causing the caption to

blink when a fault code is present on

the module, for example.

13. Click OK to save the properties.

The display updates with button

changes. For the CNC Work Cell

application example, Device 1 Goto

Button displays as Drill CNC.

14. Repeat step 1…step 13 for each CNC

Goto display button that you require.

For the CNC Work Cell application example, two of the special Goto buttons were used for the CNCs.

For the two Gantry X and Y buttons, the default Goto buttons are used. The following table describes how

the Goto buttons are configured.

Device Goto Display Button Display Setting Parameter Setting

Drill CNC Fanuc_CNC_Faceplate Drill_CNC

Machine CNC Fanuc_CNC_Faceplate Machine_CNC

Gantry X CIPMotion_Faceplate Gantry_X_Axis

Gantry Y CIPMotion_Faceplate Gantry_Y_Axis

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 277 278

Sem comentários

Rockwell-automation IASIMP Computer Numerical Control (CNC) Machining Manual do Utilizador Página 183