Rockwell-automation IASIMP Computer Numerical Control (CNC) Machining Manual do Utilizador descarregar pdf (Página 217)

Rockwell Automation Publication IASIMP-QS034A-EN-P - October 2012 217

System Application Guide Chapter 7

Machine Startup Faceplate

The machine startup faceplate display provides general machine status and control. It is also configured as the

main navigation display for access to the other devices, the alarm history faceplate display, and the equipment

status faceplate display.

Machine Status

The Machine Status indicators (OK and FAULTED) provide general machine status (refer to the figure below).

The specific indicator functions are included in the Machine Status Indicators table on page 218.

In this example, there are five Goto display buttons configured. There is one Goto display button for each of the

two CNCs, the State Diagram, the Equipment Status display, and the Alarm History display. Pressing any of the

Goto display buttons launch the associated display.

IMPORTANT

If the Machine Startup display is not visible or errors are reported on either the Logix controller or PanelView Plus

terminal, refer to previous chapters to check system wiring and configuration settings.

Drive Goto

Display Buttons

Machine Status Indicators

OK Status

Machine Control Buttons

System Goto Display Buttons

Machine Status Indicators

Faulted Status

Abort Status

Indicator

Exit HMI

Application Button

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 277 278

Sem comentários

Rockwell-automation IASIMP Computer Numerical Control (CNC) Machining Manual do Utilizador Página 217