Rockwell-automation 22-COMM-C ControlNet Adapter Manual do Utilizador descarregar pdf (Página 19)

Chapter 2

Installing the Adapter

Chapter 2 provides instructions for installing the adapter in a PowerFlex

40 or PowerFlex 400 drive. This adapter can also be installed in a DSI

External Comms Kit. In this case, refer to the 22-XCOMM-DC-BASE

Installation Instructions (Publication No. 22COMM-IN001…) supplied

with the kit.

Before installing the adapter, verify that you have all required

equipment. Refer to Chapter 1

, Getting Started.

Before installing the adapter, you must set its Operating Mode Jumper

for Single or Multi-Drive operation, and its Node Address Switches to a

unique ControlNet node address.

Important: New settings are recognized only when power is applied to

the adapter, or the adapter is reset. If you change a setting,

cycle power or reset the adapter to invoke the change.

Topic Page

Preparing for an Installation

2-1

Setting Operating Mode and Node Address Switches 2-1

Connecting the Adapter to the Network 2-3

Connecting the Adapter to the Drive 2-4

Applying Power 2-7

Preparing for an Installation

Setting Operating Mode and Node Address Switches

ATTENTION: Risk of equipment damage exists. The adapter

contains ESD (Electrostatic Discharge) sensitive parts that can be

damaged if you do not follow ESD control procedures. Static control

precautions are required when handling the adapter. If you are

unfamiliar with static control procedures, refer to Guarding Against

Electrostatic Damage, Publication 8000-4.5.2.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 163 164

Sem comentários

Rockwell-automation 22-COMM-C ControlNet Adapter Manual do Utilizador Página 19