Rockwell Automation 1203-SSS Manual do Utilizador descarregar pdf (Página 17)

Publication 1203-5.14 – September 1998

Chapter

Configuring the 1203-SSS Converter

Chapter Objectives

Chapter 3 provides information that you need to configure the

1203-SSS converter. In this chapter, you will read about the

following:

• 1203-SSS converter’s default setting.

• Equipment needed to make a serial connection to the converter.

• Connecting either a PC running terminal emulation software or a

VT100-compatible terminal to the converter.

• Navigating in the converter’s software.

• Editing the converter’s parameters.

• Viewing and clearing the converter’s event queue.

Factory-Default Settings for the

1203-SSS Converter’s Parameters

The factory-default settings of the 1203-SSS converter enable the

following functions:

• Node address of 1.

• Baud rate of 9600.

• If control data is being transmitted and a time-out occurs, the

SCANport product will be faulted by the converter.

If you wish to change any of these functions you must connect to the

converter and edit its parameters. To do so, refer to:

• Appendix B, 1203-SSS Converter Parameters, for detailed

information about each of the converter’s parameters.

• Instructions in this chapter on establishing a serial connection.

• Instructions in this chapter on how to edit the parameters.

Required Tools and Equipment

To make a serial connection to the converter, you need the following:

• 1203-SFC serial cable.

• 1203-C10 SCANport cable.

• A PC running a Windows terminal emulation program

(e.g., HyperTerminal) or DriveExplorer, or a VT100-compatible

terminal.

Establishing a Serial Connection

with the 1203-SSS Converter

The converter’s software lets you edit the converter’s parameters and

view its event queue. To access its software, you must make a serial

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Sem comentários

Rockwell Automation 1203-SSS Manual do Utilizador Página 17