Rockwell-automation SA3100 Distributed Power System Drv Config,Program Manual do Utilizador descarregar pdf (Página 47)

Configuring the UDC Module’s Registers

3-9

3.2.3 Flex I/O Status and Error Codes

The memory map is shown in table 3.6.

Table 3.6 – Register 10/22 - Flex I/O Module 0 and Module 1 Faults

Bit Name Description

0 Flex Bus Fault Set if the Flex Bus Interface on the PMI Regulator has faulted.

1 Flex Clock Warning Set if the Flex I/O clock is not running.

2 Flex Scratch Pad Warning Set if a read/write Flex I/O memory error is detected.

3 Flex Dual Port Warning Set if a read/write Flex I/O dual port memory error is detected.

8 Module 0 Not Plugged In Set if no device is detected at the Module 0 port.

9 Module 0 Communication Error Set if there is a serial communication error with Module 0.

10 Module 0 Bad ID Set if a non-supported module ID is received from Module 0 or if

the module ID received does not match the configured ID.

11 Module 0 Location Error Set if an analog module is physically located in the Flex I/O rail

location designated for Module 0, and Module 0 has been

configured for a Digital module.

12 Module 1 Not Plugged In Set if no device is detected at the Module 1 port.

13 Module 1 Communication Error Set if there is a serial communication error with Module 1.

14 Module 1 Bad ID Set if a non-supported module ID is received from Module 1 or if

the module ID received does not match the configured module

ID.

15 Module 1 Location Error Set if an analog module is physically located in the Flex I/O rail

location designated for Module 0 or Module 1, and Module 1 has

been configured for a Digital module.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 161 162

Sem comentários

Rockwell-automation SA3100 Distributed Power System Drv Config,Program Manual do Utilizador Página 47