Rockwell-automation RECOMM-ENET EtherNet/IP Communications Module Manual do Utilizador descarregar pdf (Página 17)

Getting Started

2-1

CHAPTER 2

Getting Started

This chapter provides:

• A description of the EtherNet/IP module’s components

• A list of parts shipped with the module

• A list of user-supplied parts required for installing the module

• An installation checklist

➀

Status Indicators Four LEDs to indicate the status of the connected

drive, module, and network. Refer to chapter 6 for

more information about the LEDs.

➁

DPI Connector A 20-pin, single-row shrouded male header. An

Internal Interface cable connects to this connector

and one on the drive.

➂

Ethernet

Connector

An RJ-45 connector the Ethernet cable. The

connector is CAT-5 compliant to ensure reliable

data transfer on 100Base-TX Ethernet

connections.

④

Web Page

Switch (SW2)

Enables or disables the module web pages. Refer

to Chapter 3, Setting the Web Pages Switch

(Firmware 3.xxx only). SW1 is unused.

Figure 2.1 – Components of the EtherNet/IP Module









Not provided on

firmware version 2.xxx

or earlier

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 193 194

Sem comentários

Rockwell-automation RECOMM-ENET EtherNet/IP Communications Module Manual do Utilizador Página 17