Rockwell-automation 5720 DriveLogix System Manual do Utilizador descarregar pdf (Página 222)

Publication 20D-UM002C-EN-P - November 2003

11-2 Communicating with Devices on a Third-Party Link

Step 1: Install the hardware

Before you can connect the DriveLogix system to the third-party network, you

must configure the 1788-MODULE communication card and make sure it is

properly installed in the DriveLogix controller. Refer to Access Procedures on

page C-1 to understand how to gain access to the NetLinx daughtercard slot

on the DriveLogix controller.

Remember which slot you use for which communication card. You’ll need the

slot number to configure the communication card in the RSLogix 5000

programming software. The controller uses slot 0.

Step 2: Configure the daughtercard as part of the system

Use RSLogix 5000 programming software to map the 1788-MODULE card as

part of the DriveLogix system. In the Controller Organizer, add the card to the

I/O Configuration folder.

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 262 263

Sem comentários

Rockwell-automation 5720 DriveLogix System Manual do Utilizador Página 222