Rockwell-automation 1747-ACNR15 ControlNet Adapter Module User Manual Manual do Utilizador descarregar pdf (Página 15)

Publication 1747-UM003A-EN-P

Installing Your ControlNet Adapter Module 2-3

Installing the Adapter

Module in the Chassis

Once you’ve set the appropriate switch assemblies for your adapter module,

follow these procedures for installation.

Refer to the Industrial Controller Wiring and Grounding Guidelines, Publication

1770-4.1 for proper grounding and wiring methods to use when installing

your module.

1. Remove power from the I/O chassis before inserting (or removing) the

module.

2. Align the circuit board with the chassis card guide in the left slot.

3. Slide the module into the chassis until the top and bottom latches are

latched. To remove the module, press the releases at the top and bottom

of the module and slide it out.

4. Press firmly and evenly to seat the module in its backplane connectors.

ATTENTION

Remove system power before removing or installing your

module in the I/O chassis. Failure to observe this warning

could damage module circuitry and injure people.

ATTENTION

Do not force the module into the backplane connector. If

you cannot seat the module with firm pressure, check the

alignment. Forcing the module can damage the backplane

connector or the module.

Card Guide

Power

Supply

Latch

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 139 140

Sem comentários

Rockwell-automation 1747-ACNR15 ControlNet Adapter Module User Manual Manual do Utilizador Página 15