Rockwell-automation 1771-OWN Selectable Contact Installation Instructi Manual do Utilizador

Publication 1771-IN037B-EN-P - July 2002SelectableContact Output Module(Catalog Number 1771–OWN)Use this document as a guide when installing the catal

Selectable Contact Output Module10Publication 1771-IN037B-EN-P - July 2002!ATTENTIONDo not attempt to increase load current or wattagecapability beyo

Selectable Contact Output Module 11Publication 1771-IN037B-EN-P - July 2002The module has 32 status indicators on the module front plate. Theserepres

Selectable Contact Output Module12Publication 1771-IN037B-EN-P - July 2002The following information applies when operating this equipment inhazardous

Specifications Selectable Contact Output Module 13Publication 1771-IN037B-EN-P - July 2002Outputs per module 32 (4 groups of 8)Module Location 1771ĆA1

Selectable Contact Output Module14Publication 1771-IN037B-EN-P - July 2002Conducted RF Immunity IEC 61000-4-610V rms with 1kHz sine wave 80% AM from

Selectable Contact Output Module 15Publication 1771-IN037B-EN-P - July 2002

Selectable Contact Output Module16Publication 1771-IN037B-EN-P - July 2002Publication 1771-IN037B-EN-P - July 2002Supersedes Publication 1771-5.37 -

Selectable Contact Output Module2Publication 1771-IN037B-EN-P - July 2002Reproduction of the contents of this copyrighted publication, inwhole or par

Selectable Contact Output Module 3Publication 1771-IN037B-EN-P - July 2002ATTENTION!Environment and EnclosureThis equipment is intended for use in a

Selectable Contact Output Module4Publication 1771-IN037B-EN-P - July 2002!ATTENTIONPreventing Electrostatic DischargeThis equipment is sensitive to e

Selectable Contact Output Module 5Publication 1771-IN037B-EN-P - July 2002Key the BackplaneConnectorPlace your module in any slot in the chassisexcep

Selectable Contact Output Module6Publication 1771-IN037B-EN-P - July 20023. Reinstall the circuit board in the module and replace the cover.Table AJu

Selectable Contact Output Module 7Publication 1771-IN037B-EN-P - July 2002!ATTENTIONRemove power from the 1771 I/O chassisbackplane before you instal

Selectable Contact Output Module8Publication 1771-IN037B-EN-P - July 2002Make wiring connections to the module through the field wiring arm(cat. no.

Selectable Contact Output Module 9Publication 1771-IN037B-EN-P - July 20023. Make your connections to the field wiring arm as shown in theconnection