Rockwell-automation RECOMM-DNET DeviceNet Adapter for use with DPI AC Manual do Utilizador descarregar pdf (Página 99)

DeviceNet Adapter Parameters

B-7

Sets the Logic Command data that is sent to the drive if the

following is true:

• Comm Flt Action (10) is set to Send Flt Cfg and communications

are disrupted.

• Idle Flt Action (11) is set to Send Flt Cfg and the scanner is put

into Program or Test mode.

• Peer Flt Action (34) is set to Fault Cfg and communications are

disrupted.

The bit definitions will depend on the product to which the adapter is

connected.

Sets the Reference data that is sent to the drive if any of the

following is true:

• Comm Flt Action (10) is set to Send Flt Cfg and communications

are disrupted.

• Idle Flt Action (11) is set to Send Flt Cfg and the scanner is put

into Program mode.

• Peer Flt Action (34) is set to Fault Cfg and the scanner is put into

Program mode.

• Peer Flt Action (34) is set to Fault Cfg and communications are

disrupted.

Important: If the drive uses a 16-bit Reference, the most significant

word of this value must be set to zero (0) or a fault will

occur.

15 Flt Cfg Logic

Range:

0000 0000 0000 0000 to 1111 1111 1111 1111

Default:

0000 0000 0000 0000

Type:

Read/Write

Reset Required:

16 Flt Cfg Ref

Range:

0 to 4294967295

Default:

Type:

Read/Write

Reset Required:

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 167 168

Sem comentários

Rockwell-automation RECOMM-DNET DeviceNet Adapter for use with DPI AC Manual do Utilizador Página 99