Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Manual do Utilizador descarregar pdf (Página 31)

Basics of Programming the Drive Using the OIM

4-1

HAPTER

Basics of Programming the Drive

Using the OIM

To program the drive using the OIM, you change the settings for parameters that affect

your application. This chapter describes how to:

•

access the parameters and make changes to them

•

restore factory default values for the parameters

•

use a password to protect your programming

For parameter descriptions and general information about parameters, see the

software I/M.

Appendix A of this I/M lists the OIM parameter names cross-referenced to the

parameter names used in the software I/M.

Appendix B of this I/M describes the full menu paths for accessing the parameters.

4.1 Accessing OIM Menus and Parameters

OIM menus and parameters are accessed in program mode. To select program mode,

press until the key indicator says PROGRAM.

If you exit from a menu or parameter list using

the last menu or parameter that

was displayed is displayed when you return to program mode. To go to the Main Menu

in this case, press

until GV3000 Main Menu is displayed at the top of the

screen.

4.1.1 Accessing the Menus

When you enter program mode for the first time after power up, the Main Menu is

displayed, as shown in figure 4.1. Other menus are accessed from the Main Menu.

ATTENTION:

Only qualified electrical personnel familiar with the

construction and operation of this equipment and the hazards involved should

install, adjust, operate, and/or service this equipment. Read and understand

this section in its entirety before proceeding. Failure to observe this precaution

could result in severe bodily injury or loss of life.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 111 112

Sem comentários

Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Manual do Utilizador Página 31