Rockwell-automation 1785-ENET USER MANUAL PLC-5 ETHERNET INTERFACE Manual do Utilizador descarregar pdf (Página 24)

1785-6.5.19 November 1998

2-8 Installing the Interface Module

Removing the Interface Module To remove the interface module from its installed position, follow the

instructions below.

Remove power to

the 1771 I/O chassis.

Lift the locking bar up and away from

the processor and interface module.

Lift the ejector tabs on the front of each

module simultaneously and remove the

connected modules.

Remember to wear a grounding

wrist strap to guard against ESD.

Ejector

tabs

Loosen the four screws on the side of

the interface module.

PLC-5

processor

Separate the interface

module from the processor

by placing your finger

tips between the two

modules. Pull directly

and evenly upward.

Do not pry the interface module away from the

processor by pulling on one corner or side.

You will bend the connector header's pins.

Ethernet Interface Module

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 53 54

Sem comentários

Rockwell-automation 1785-ENET USER MANUAL PLC-5 ETHERNET INTERFACE Manual do Utilizador Página 24