Rockwell-automation 1762-OA8 Solid State Output Module Manual do Utilizador descarregar pdf (Página 7)

Solid-State Output Module 7

Publication 1762-IN007B-EN-P- June 2013

System Assembly

The expansion I/O module is attached to the controller or another I/O module by means of a

flat ribbon cable after mounting as shown below.

Field Wiring Connections

Grounding the Module

This product is intended to be mounted to a well-grounded mounting surface such as a metal

panel. Refer to Industrial Automation Wiring and Grounding Guidelines, Allen-Bradley

publication 1770-4.1, for additional information.

TIP

Use the pull loop on the connector to disconnect modules. Do not pull on

the ribbon cable.

ATTENTION

EXPLOSION HAZARD

• In Class I, Division 2 applications, the bus connector must be fully

seated and the bus connector cover must be snapped in place.

• In Class I, Division 2 applications, all modules must be mounted in

direct contact with each other as shown on Page 6. If DIN rail

mounting is used, an end stop must be installed ahead of the controller

and after the last 1762 I/O module.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Sem comentários

Rockwell-automation 1762-OA8 Solid State Output Module Manual do Utilizador Página 7