Rockwell-automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardP Manual do Utilizador descarregar pdf (Página 46)

Publication 1753-PM001A-EN-P - November 2005

3-6 Create a GuardPLC Project

Create Signals in the Signal Editor

1. To open the Signal Editor, choose Signals > Editor from the

Hardware Management menu bar.

2. Create 3 new signals, START, STOP, and MOTOR:

a. Left-click on New Signal in the Signal Editor. Type START in

the Name field and press the Enter key.

b. Left-click on New Signal again. Type STOP in the Name field

and press the Enter key.

c. Left Click on New Signal again. Type MOTOR in the Name

field and press the Enter key.

Connect Signals to I/O

Terminals

Connect signals to I/O by dragging the signals from the Signal Editor

to the Input or Output tabs of the Connect Signals dialog.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 121 122

Sem comentários

Rockwell-automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardP Manual do Utilizador Página 46