Rockwell-automation 160 SSC Remote Keypad User Manual Manual do Utilizador

Bulletin 160 SSC™Remote Keypad FRN 1.xUser Manual

1-6 Introduction Display Description The keypad has a four-character LED display which shows parameter numbers, parameter values, and fault codes. Th

Introduction 1-7 Keypad Initialization Sequence When the Remote Keypad is connected to the drive, and power is applied, the following is displayed fo

1-8 Introduction End of Chapter

Chapter 2 Installation Prepare Mounting Location • Select a mounting location that is less than 5 meters away from the drive. Connection cables are

2-2 Installation Mount the Remote Keypad Installation and Torque Sequence Figure 2.21534621241534623No GapTemporary Torque0.3 N-m(2.7 in-lb)Final Tor

Chapter 3 Control the Drive Enable Keypad Control to Start the Drive The following steps also serve as a programming example.1. With the Remote Keyp

3-2 Control the Drive Stop the Drive Use the Stop key to command the drive to stop. The Stop key functions in all drive input modes whether or not th

Chapter 4 Troubleshooting How to Clear a Fault When a fault occurs, the cause must be corrected before the fault can be cleared. After corrective ac

4-2 Troubleshooting DRAFT – 7/19/99 Resolving Problems Important: The connector cable, RPA, and Keypad are not repairable. Description Cause Action D

Appendix A Technical Specifications DimensionsAmbient Conditions • Operating temperature: 0˚ C to 50˚ C (32˚ F to 122˚ F)• Storage temperature: -40˚

Important User Information Solid-State equipment has operational characteristics differing from those of electromechanical equipment. “Safety Guidel

A-2 Technical Specifications Maintenance Use only a soft cloth dampened with water to clean the keypad.The RPA requires no maintenance or cleaning. A

Publication 0160-5.28ML – September, 1999 P/N 194308 (01) Copyright 1999 Rockwell International Corporation. All rights reserved. Printed in USA.

Table of Contents Introduction Drive Compatibility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

ii

Chapter 1 Introduction The Remote Keypad can be used to change drive parameter values, monitor operating conditions, and control drive operation. Im

1-2 Introduction Remote Programming Adapter The Remote Programming Adapter (160-RPA) allows the Remote Keypad to interface with a Bulletin 160 Series

Introduction 1-3 Grounding It is required that the Remote Programming Adapter be earth grounded to improve noise immunity and to guard the Remote Key

1-4 Introduction Connector Cable A cable is used to connect the Remote Keypad to the Bulletin 160 Series C drive. The Keypad can be connected and dis

Introduction 1-5 Features The figure and table below identify and describe the Remote Keypad display, status indicators, and keys. Remote Keypad Featu