Rockwell-automation 150 USE MN/SMC DIALOG + CONTROLLER Manual do Utilizador descarregar pdf (Página 112)

Serial Communications

8-3

SMC Status Data

The information in Table 8.B provides the SMC Dialog Plus

controller status information that can be sent to the logic controller’s

input image table.

Table 8.B SMC Status Data

①

When control power is applied, this bit is always set to 1.

Reference/Feedback

The SMC Dialog Plus controller does not support the analog

reference feature of SCANport. The SCANport analog feedback

feature, however, is supported. The feedback word will always be

equal to Parameter number 4, Current Phase A.

Parameter Listing

Refer to Appendix B, Table B.1 for a complete listing of the SMC

Dialog Plus controller’s parameters and groups. In addition to the

range of adjustments, the parameters’ units are provided.

Scale Factor

Conversion

The parameter values of the SMC Dialog Plus controller are stored as

unscaled numbers. When reading parameter data in the PLC/SLC’s

input image table, divide this number by the scale factor shown in

Appendix B, Table B.1 to arrive at the proper value.

When writing from the PLC/SLC’s output image table to the SMC

Dialog Plus controller, the scale factor must be taken into

consideration to ensure that the proper value is sent.

Logic Bits

Description Definition

1514131211109876543210

Enabled

①

1 = Enabled

0 = Not Enabled

X Running

1 = Running

0 = Not Running

Not Used —

XStarting

1 = Starting

0 = Not Starting

X Stopping

1 = Stopping

0 = Not Stopping

X Fault

1 = Faulted

0 = Not Faulted

XAt Speed

1 = At Speed

0 = Not at Speed

Bits 9–15 are not used

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 188 189

Comentários a estes Manuais

Sem comentários

Rockwell-automation 150 USE MN/SMC DIALOG + CONTROLLER Manual do Utilizador Página 112

Comentários a estes Manuais

Manuais e produtos relacionados com Equipamento Rockwell-automation 150 USE MN/SMC DIALOG + CONTROLLER