Rockwell-automation Logix5000 Control Systems: Connect POINT I/O Modul Manual do Utilizador descarregar pdf (Página 8)

8 Rockwell Automation Publication IASIMP-QS026A-EN-P - July 2012

Preface

Other Logix5000 Control System Quick Starts

This quick start describes how to use a single component-type over a single network in a

Logix5000 control system. Typically, though, a Logix5000 control system includes more than

the controller, communication module and a single component over a single network.

For example, if a Logix5000 control system operates on a DeviceNet network, the system might

use remote I/O modules, HMI devices and drives in addition to the controller and

communication modules.

For a complete list of Logix5000 control system quick starts that describe how to other devices in

Logix5000 control systems, see the Integrated Architecture:Logix 5000 Control Systems Quick

Starts Quick Reference, publication IASIMP-QR024

The beginning of each chapter contains the following information. You should read these

sections before beginning work in each chapter:

• Before You Begin - This section lists the tasks you must complete before starting the

chapter.

• What You Need - This section lists the tools that are required to complete the tasks in the

current chapter. This includes, but is not limited to, hardware and software.

• Follow These Steps - This section illustrates the steps in the current chapter.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 61 62

Sem comentários

Rockwell-automation Logix5000 Control Systems: Connect POINT I/O Modul Manual do Utilizador Página 8