Rockwell-automation HPK-Series Asynchronous Servo Motor Manual do Utilizador descarregar pdf (Página 13)

HPK-Series Asynchronous Servo Motors 13

Publication HPK-IN001C-EN-P - June 2010

7. Connect the power cable leads (U/T1, V/T2, and W/T3) to the power terminals.

8. Connect the ground and shield connect to the ground lug.

9. Connect the other end of the power cable to the three-phase 380…460V AC power

outputs on the controller as described in the instruction manual for that device.

Proper grounding of power cable shielding is essential for error-free operation. Refer to

the instruction manual of your drive for recommended grounding techniques.

10. Connect blower leads to the three-phase 380…460V ac power source as outlined in the

table below and shown in the Blower Wiring Diagrams

on page 14.

AC Input to Motor

Connect Input with Wire Color to Terminal M8 Clamping

Bolt Torque

M6 Cover

Threaded Bolt

Torque

Line 1 Black U/T1 14 N•m (1.6 lb-in.) 8 N•m (0.9 lb-in.)

Line 2 Blue V/T2

Line 3 Brown W/T3

Ground Green/Yellow GND

Shield Yellow/Green

ATTENTION: The motor is at line voltage when ac power is connected.

Disconnect and lockout all ungrounded conductors of the ac power line before

attempting any to connect or disconnect power wiring at the motor.

Failure to observe these precautions could result in severe bodily injury or loss

of life.

AC Input to Blower (380…460V)

Connect Input with Wire Color to Terminal

Line 1 Black U

Line 2 Blue V

Line 3 Brown W

Ground Green/Yellow GND

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Sem comentários

Rockwell-automation HPK-Series Asynchronous Servo Motor Manual do Utilizador Página 13