Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Manual do Utilizador descarregar pdf (Página 488)

Angled-Wheel Grinding

If you last entered W axis values, those values are transformed over to the

X axis for angled wheel mode. If you last entered X axis values those

values are transformed over to the W axis for non-angled wheel mode.

ATTENTION: Changing the wheel axis angle results in a

change to the programmable zone area. As the wheel axis

approaches 90 degrees, the protected area of the programmable

zone approaches zero. Areas once protected by the

programmable zone can become unprotected when the wheel

angle changes. Additionally areas once accessible can become

unaccessible as the wheel axis angle changes. You must

recalculate and reenter your programmable zones limits any

time the wheel axis angle is changed.

END OF CHAPTER

Sem comentários

Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Manual do Utilizador Página 488