Rockwell-automation 5370-UPK CVIM USER-PAK Option Manual do Utilizador descarregar pdf (Página 54)

Chapter 7

Creating Custom Runtime Displays

7–3

This section describes the initial steps to use in defining a viewport. To

define a viewport:

• Insert the Setup card into the Archive Memory slot on the CVIM module.

• Pick the Env. → Config. Output boxes to display the Config. Output

menu; this also displays the viewport (if a viewport is currently selected):

Viewport Border

Viewport 1 selected

Config. Output box selected

• Select the specific viewport you are going to define using the

corresponding Previous/Next boxes. The selected viewport appears on

the screen.

Picking the Next box repeatedly cycles though the selection of Viewports

1–40, then Serial Port A, Serial Port B, then Viewports 1–40, etc.

Picking and holding the Next or Previous box causes the Define

Viewport number to increment/decrement continually.

Tool Display Setting: With the Env.→ System→ Tool Display: box set

to ON, all viewports are displayed which have an assigned display page

and number in common with the currently selected viewport. With Tool

Display: box set to OFF, only the current viewport is displayed (see

“Selecting Display Pages and Page Numbers” in this chapter).

Initial Setup: Selecting and

Defining the Viewport

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 141 142

Sem comentários

Rockwell-automation 5370-UPK CVIM USER-PAK Option Manual do Utilizador Página 54