Rockwell-automation 2755 AtomScan Bar Code Reader Manual do Utilizador descarregar pdf (Página 13)

1–5Introduction to AtomScan

Bar Code Readers

Publication 2755-6.9

7. Apply power to the scanner system.

Reference

After all of your hardware components are installed, apply power to your scanner system. Push the

power button in on the interface box.

Chapter 4

(Installing Your

Hardware)

Front View of the Interface Box

Power Switch

8. Check the reader defaults.

Reference

Check the following configuration parameters on your host device. (Make sure you have a

Windows

t terminal utility software on your personal computer.) Make sure the defaults match the

settings listed below. If the defaults do not match, communication between the reader and host

device will not occur.

• baud rate = 9600

• parity = even

• stop bits = one

• data bits = 7

Chapter 5

(Configuring Your

Reader)

Read a test bar code to verify that the default settings are correct (i.e., the reader is communicating

with the configuration device).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 140 141

Sem comentários

Rockwell-automation 2755 AtomScan Bar Code Reader Manual do Utilizador Página 13