Rockwell-automation 1771-DB Basic Module User Manual - Series A Manual do Utilizador descarregar pdf (Página 15)

Chapter 3

Installing the BASIC Module

This chapter describes how to install your BASIC module in a 1771 I/O

rack. After reading this chapter you should be able to:

configure the module using the configuration plugs.

insert the module into a 1771 I/O backplane.

understand module status indicators.

install additional EPROM’s.

WARNING: Disconnect and lockout all AC power from the

programmable controller and system power supplies before

installing modules to avoid injury to personnel and damage to

equipment.

Read this installation section completely before beginning. Re-check all

option selections and connections before you begin programming.

Before installing your module in the I/O chassis you must:

1. calculate the power requirements of all the modules in each chassis.

(Refer to Section 3.2.1 below).

2. determine the location of the module in the I/O chassis. (Refer to

Section 3.2.2 below).

3. key the backplane connectors in the I/O chassis. (Refer to Section

3.2.3 below).

4. set the module configuration plugs. (Refer to Section 3.2.4 below).

3.1

Chapter

Objectives

3.2

Installing the BASIC module

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 166 167

Sem comentários

Rockwell-automation 1771-DB Basic Module User Manual - Series A Manual do Utilizador Página 15