Rockwell-automation 1746-NI8 SLC 500 Analog Input Module Instructions Manual do Utilizador descarregar pdf (Página 8)

SLC 500™ Analog Input Module

Publication 1746-IN006A-US-P

Terminal Block Removal

To remove the terminal block:

1. Loosen the two terminal block release screws.

2. Grasp the terminal block at the top and bottom and pull outward and down.

Switch Settings to Select Voltage or Current Input

Before installing the module in the chassis, use the DIP switches on the module

circuit board to select between voltage and current inputs for channels 0 through 7.

The switch settings are

• OFF = VOLTAGE INPUT

• ON = CURRENT INPUT.

Terminal Block Release

Screws

Maximum Torque =

0.7 to 0.9 Nm (6 to 8 in-lbs)

VOLTAGE

CURRENT

CH7CH0

@JO"VTQQE@JO"VTQQE ".".

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Sem comentários

Rockwell-automation 1746-NI8 SLC 500 Analog Input Module Instructions Manual do Utilizador Página 8