Rockwell-automation 1734-IT2I Thermocouple and RTD Input Module User M Manual do Utilizador descarregar pdf (Página 31)

Publication 1734-UM004F-EN-E - December 2012

Configure Your Module 21

The out-of-the-box node setting for 1734 modules is 63. You can change the

setting by using the node commissioning tool. The node commissioning tool is

available either online or offline.

1. Go to the Tools pull-down menu.

2. Select Node Commissioning.

3. Click Browse.

4. Select the module to change.

5. The node commissioning dialog

returns. It displays the node number

and data rate.

6. Change the node number and

Apply, noting that the dialog then

identifies the new setting.

7. Click Close to continue.

IMPORTANT

If you commission a node online, you must power down your

system before the change takes place.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 83 84

User Manual 1
Important User Information 2
Table of Contents 3
Appendix B 5
Accuracy Drift 5
Summary of Changes 7
Who Should Use this 9
Purpose of this Manual 9
Common Techniques Used 10
About POINT I/O Modules 11
Selecting a Module Input 12
Communicating with Your 12
(catalog number 1734-IT2I) 13
Use Module Alarms 15
(1734-IT2I module) 16
Chapter Summary 16
Cold Junction 16
Compensation 16
Install the Module 17
Install the Mounting Base 18
1734-IT2I shown 19
Install an I/O Module 20
1734-RTD - Position 6 21
1734-IT2I - Position 6 21
Install the Removable 22
Terminal Block 22
Remove a Mounting Base 23
Wire the Modules 24
Configure Your Module 27
IMPORTANT 28
Add the Adapter to Your 29
Set the Thermocouple Input 32
Module Parameters Using 32
RSNetWorx 32
Setting Parameters 33
Configure Your 34
Thermocouple Input 34
Advanced Setup Parameters 35
Basic Setup 37
Advanced Setup 38
Set the RTD Input Module 39
Parameters Using 39
Configure Your RTD Input 41
Check I/O Status and View 46
Calibrate Your Module 49
Calibrate the Thermocouple 50
Input Module 50
ATTENTION 51
Click Device Parameters to 51
Input (mV) Calibration 52
Select Cold Junction 0, Cold 55
Tools and Equipment 58
Required to Calibrate 58
Your RTD Module 58
Calibrate the RTD Input 58
Troubleshoot the Module 63
Appendix 65
Overview 65
Understanding Data 65
Connection, and 65
Communication Formats 65
Use the Help Button 67
Working with Dialogs 67
Alarm Configuration Dialog 69
Calibration Dialog 70
Configuration Dialog 72
Alarm Configuration Dialog 74
Full Scale Values 80
72 Index 82
73 83
Rockwell Automation Support 84
Documentation Feedback 84

Comentários a estes Manuais

Sem comentários

Rockwell-automation 1734-IT2I Thermocouple and RTD Input Module User M Manual do Utilizador Página 31

Comentários a estes Manuais

Manuais e produtos relacionados com Equipamento Rockwell-automation 1734-IT2I Thermocouple and RTD Input Module User M