Rockwell-automation 1560E SMC Flex Smart Motor Controller Manual do Utilizador descarregar pdf (Página 112)

8-4 Communications

1560E-UM050B-EN-P - June 2013

Connecting the Human Interface Module to the Controller

Figure 8.1 shows the connection of the SMC-Flex controller to a human

interface module. Table 8.C provides a description of each port.

See Figure 1.24 or 1.27 for the control wiring diagram that enables start-stop

control from a human interface module.

Port 5 – DPI Communications

Port 2

Ports 2 and 3 when two HIMs

are connected with a splitter

Port 5 – DPI Communications

Port 2

Ports 2 and 3 when two HIMs

are connected with a splitter

Figure 8.1 – SMC-Flex Controller with Human Interface Module

Table 8.C – Description of Ports

Port # Description

1 Unused – Not available for use

2 First 20-HIM connected to SMC-Flex

3 Second 20-HIM connected to SMC-Flex

5 DPI Communication Board port

Control Enable

To enable motor control from a connected human interface module, follow

the procedure below with the connected human interface module’s

programming keys.

The Bulletin 20-HIM-LCD human interface modules with control panels

can start and stop the SMC-FLEX controller. However, the factory default

settings disable control commands other than Stop through the serial

communication port.

To enable motor control from a connected human interface module or

communication module, you must take the following programming steps:

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 197 198

Sem comentários

Rockwell-automation 1560E SMC Flex Smart Motor Controller Manual do Utilizador Página 112