Rockwell-automation Migrating PanelView Enhanced Terminal Applications Manual do Utilizador descarregar pdf (Página 44)

44 Publication 2711P-QS001A-EN-P - October 2007

Chapter 6 Review Unsupported Features and Implement Workarounds for Migration Issues

Communications (RIO) Passthrough Downloads Use an Ethernet connection or a CompactFlash card

to transfer files.

Remote I/O Connector Wiring The Remote I/O connector wiring for the PanelView

Plus terminal is reversed from the PanelView 1000e

and 1400e terminals.

Remote I/O Tag with Blank Address Remote I/O tags with blank addresses are converted

to HMI memory tags. An error is recorded in the

conversion log.

Data Types Bit Position If a bit position data type does not reference a single

bit, it is converted to an HMI memory tag. An error is

recorded in the conversion log.

• Create an expression to isolate the bits used to

drive the state of the display object, such as a

multistate indicator.

For information on how to implement this

workaround, refer to page 80.

• For write objects, such as push buttons, there is

no workaround except to change the ladder logic.

• For Remote I/O, you may need to change the

Rack/Block Transfer configuration.

• For DH+ and ControlNet, unscheduled tags with

the bit position data type are converted to HMI

analog tags with a data type of default.

Binary A binary tag is converted to an HMI memory tag if it

does not reference:

• a single bit.

• a single word.

• a length or range of 8 or 16 bits and does not

start at an offset of 0 or 8 (SLC controller) or 10

(PLC-5 controller).

An error is recorded in the conversion log.

• Create an expression to isolate the bits used to

drive the state of display object, such as a

multistate indicator.

• For write objects such as push buttons, there is

no workaround.

BCD BCD data types are not supported: 1-BCD, 2-BCD,

5-BCD, 6-BCD, 7-BCD, 8-BCD.

Tags that use this data type are converted to analog

tags with the default data type. The default data

type uses floating point values.

Byte If the byte address does not have a bit offset of 0 or

8, it is converted to an HMI memory tag. The error is

recorded in the conversion log

Unsupported Objects or Features in FactoryTalk View Machine Edition

For this PanelBuilder 1400e object These features are unsupported

in FactoryTalk View ME software

Additional Information

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 159 160

Comentários a estes Manuais

Sem comentários

Rockwell-automation Migrating PanelView Enhanced Terminal Applications Manual do Utilizador Página 44

Comentários a estes Manuais

Manuais e produtos relacionados com Equipamento Rockwell-automation Migrating PanelView Enhanced Terminal Applications