Rockwell-automation DeviceLogix System User Manual Manual do Utilizador descarregar pdf (Página 199)

Publication RA-UM003B-EN-P - February 2010 199

RSNetWorx for DeviceNet Software and the DeviceLogix Editors Appendix B

To start the DeviceLogix Editor for a DeviceLogix-enabled device,

click Start Logic Editor. On the DeviceLogix Editor Style Selection

dialog, you are prompted to select the editor type that you want to

launch. After selecting an editor type, click OK.:

If the current device does not support one of the editor types, no

selection will be presented.

For more information on the Function Block Editor, refer to Chapters

2 and 3. For more information on the old Ladder Editor, refer to

Chapters 4 and 5. For more information on the new Ladder Editor,

refer to Chapters 6 and 7.

IMPORTANT

If you select an editor type for a particular device and that type

is committed to the .dnt file (clicking OK or Apply), that editor

style is registered. Therefore, you cannot switch to another

editor style in that same .dnt file (the next time you launch the

DeviceLogix Editor Style Selection dialog, the other editor style

is grayed out). If you want to change the editor type (and a

device supports both editor types), you must create a new

project file, delete this device and add it again, and then select

the other editor type.

1 2 ... 194 195 196 197 198 199 200 201 202 203 204 ... 208 209

Sem comentários

Rockwell-automation DeviceLogix System User Manual Manual do Utilizador Página 199