Rockwell-automation AutoMax Prog Exec V4.2 and Dist. Power System Driv Manual do Utilizador descarregar pdf (Página 15)

5Ć3

 



Install the sharedĆuser Executive on each network node that will

access it following the directions below. This procedure must be

performed after installing the sharedĆuser Executive on the network

server.

Step 1. From a node workstation, log on to the network from the

Windows 95 Task bar, click Start, then Run, and enter the

directory that contains the Executive software (e.g.,

<DRV>:\<RPE>\<AMX4>). Type:

INSTALL.EXE

Step 2. A message will be displayed that describes the Shared

User Node Installation. Select OK" to begin the

installation procedure. The Executive *.INI file will be

copied to the local hard drive and AutoMax icons will be

created in the AutoMax program folder.

Step 3. A text file, README.AMX, contains information on the

enhancements made for AutoMax V4.x. You will be

prompted for whether you want to read the file or not. If

you select Y

es", the file will be displayed. If you select

No", you can read or print out the file later by selecting

the Read Me" icon from the AutoMax Executive folder.

Step 5. The following line will be added to the AUTOMAX

.INI file

by the install procedure:

EXEC_DRIVE=<DRV>:\<RPE>\<AMX4>

Beta = Y

where <drive:\subdirectory> is the drive and

subdirectory where the Executive software was installed.

Step 6. When the installation has been completed, a message

will be displayed.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Sem comentários

Rockwell-automation AutoMax Prog Exec V4.2 and Dist. Power System Driv Manual do Utilizador Página 15