Rockwell-automation 61C23 AutoMate Local I/O Head Manual do Utilizador descarregar pdf (Página 12)

3Ć2

Step 5. Connect the Local I/O Interface cable between the Local

I/O Head connector labeled INPUT and any Rail connector

on the hardware with which the Head will communicate.

Note that you can substitute the I/O Rail cable (M/N 45C5)

for the Local I/O Interface cable (M/N 45C8) in step 5

above. You cannot, however, substitute the Local I/O

Interface cable for the I/O Rail cable. If you do so, the Rail

will not operate.

Step 6. Verify that power was disconnected from the wires that will

be used to provide power to the Head.

Step 7. For M/N 61C22, connect 120 VAC and ground wiring to

the terminals on the Head faceplate as follows:



 

120 VAC hot L1

120 VAC neutral L2

ăăăăăăă- GND

Each screw terminal can accommodate no. 12 AWG wires. Minimum

wire size is 22 AWG.

ąąąor

For M/N 61C23, connect 24/48 VDC and ground wiring to the

terminals on the Head faceplate as follows:



 

+24/48 VDC +

ăăăCommon Com

ăăăăăăă-

Each screw terminal can accommodate no. 12 AWG wires. Minimum

wire size is 22 AWG.

Step 8. Check the installation for proper connections, safety

covers, protective devices, and means of disconnection.

Verify that the equipment is ready to apply power.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Sem comentários

Rockwell-automation 61C23 AutoMate Local I/O Head Manual do Utilizador Página 12