Rockwell-automation 6181P-xxxx Integrated Display Computers, Series A Manual do Utilizador descarregar pdf (Página 29)

29Publication 6181P-UM001G-EN-P - July 2008 29

Chapter

3

Operation

Chapter Objective

This chapter covers the following topics:

• General operating guidelines

• Operator access to computer

• Booting the system

• Resetting the system

• Installing drivers

• Universal serial bus (USB) ports

Operating Guidelines

Follow these operating guidelines for your computer.

• Avoid turning the system on and off frequently.

• Always use the proper power down procedures as required by

your operating system, such as the Shut Down command in

Microsoft Windows. Failure to do so can result in performance

degradation and eventual system damage.

• Do not operate the computer with the covers removed. An

electrical shock hazard exists. Removing the covers will disrupt

air flow and may result in overheating. All covers are required to

maintain EMI shield.

• To avoid dust and other airborne contamination infiltrating the

product when mounted in a suitable enclosure, the door to the

enclosure must be closed at all times during operation. The door

should be open for routine maintenance only.

Operator Access

Operator access is limited to the front panel of the computer. This

includes the display and touchscreen. Access to components behind

the panel in which the computer is installed is restricted to authorized

and properly trained personnel.

ATTENTION

After shutting the system off, do not move the computer, or turn

it back on again, until the hard drive comes to a complete stop,

which takes about 30 seconds.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 71 72

Comentários a estes Manuais

Sem comentários