Rockwell-automation 2706-DXX Dataliner Message Display DL5 Series Manual do Utilizador descarregar pdf (Página 90)

2706-UM001A-US-P

12-2 Installation Instructions

Mounting the DL5

You can mount the DL5 in a custom panel or enclosure.

When the DL5 is properly installed, the faceplate of the DL5 provides a

NEMA Type 12/13 and 4 enclosure integrity rating. To mount the DL5:

1. Punch and drill the appropriate mounting holes in the enclosure or panel.

The following page shows the mounting dimensions of the DL5.

2. Remove the four nuts from the mounting studs on the DL5’s face plate.

3. Install the display in the panel cutout and tighten the four nuts on the

mounting studs to a torque of 9 lb-in (1.02Nm).

ATTENTION: To avoid ground loops and damage to the

equipment, the same power supply must be used for the parallel

port and the power input to the DL5.

ATTENTION: DO NOT install the DL5 until all cutouts and

holes are completed. Metal filings may fall into and damage

the DL5.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 118 119

Sem comentários

Rockwell-automation 2706-DXX Dataliner Message Display DL5 Series Manual do Utilizador Página 90