Rockwell-automation 193-DNCT DeviceNet Configuration Terminal User Man Manual do Utilizador descarregar pdf (Página 11)

Rockwell Automation Publication 193-UM009B-EN-P - February 2013 7

Chapter 2

Installation and Wiring

The DNCT ships complete with a 1 m cable (193-CB1) for connection to a

DeviceNet™ network. This cable has a plug connection to the terminal on one

end, and color coded bare leads on the other end. Alternately, a 1 m cable (193-

CM1) can be ordered that has a plug connection to the terminal on one end, and

a DeviceNet™ male micro style connector on the other end. A bezel mounting kit

(193-DNCT-BZ1) is available for mounting the terminal to a panel door.

193-CB1 Physical Connections

The 193-CB1 cable that ships with the Configuration Terminal has a plug

connection to the terminal on one end, and color coded bare leads on the other

end. The cable’s bare leads are wired to a DeviceNet™ connector according to the

following table:

193-CM1 Physical Connections

The optional Cat. No.193-CM1 has a plug connection to the terminal on one

end and a DeviceNet™ male micro-style connector on the other end. The cable’s

micro connector pin-out is shown in Figure 1 -

Figure 1 - Cat. No. 193-CM1 Pinout

Signal Function Color

V- Common Black

Can_L Signal Low Blue

Drain Shield Non-insulated

Can_H Signal High White

V+ Power Supply Red

Drain

Can_L

Can_H

V+

V-

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 91 92

Sem comentários

Rockwell-automation 193-DNCT DeviceNet Configuration Terminal User Man Manual do Utilizador Página 11