Rockwell-automation 1794-L34 FlexLogix Controller System User Manual Manual do Utilizador descarregar pdf (Página 15)

15 Publication 1794-UM001G-EN-P - January 2007

Chapter

Directly Connect to the Controller via the

Serial Port

Use This Chapter

This chapter describes how to connect to the controller via the serial

port so you can configure the controller and upload and/or download

a project to the controller.

For the FlexLogix controller to operate on a serial network, you need:

• a workstation with a serial port

• RSLinx software to configure the serial communication driver

• RSLogix5000 programming software to configure the serial port

of the controller

Connect the Controller via

the Serial Port

The RS-232 port is a non-isolated serial port built-in to the front of the

FlexLogix controller.

1. Determine whether you need an isolator.

If you connect the controller to a modem or an ASCII device,

consider installing an isolator between the controller and

modem or ASCII device. An isolator is also recommended when

connecting the controller directly to a programming workstation.

See:

• EtherNet/IP Modules in Logix5000

Control Systems User Manual,

ENET-UM001

• ControlNet Modules in Logix5000

Control System User Manual,

CNET-UM001

• DeviceNet Modules in Logix5000

Control System User Manual,

DNET-UM004

For this information See

Connect the Controller via the Serial Port 15

Configure the Serial Driver 18

Select the Controller Path 20

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 129 130

Sem comentários

Rockwell-automation 1794-L34 FlexLogix Controller System User Manual Manual do Utilizador Página 15