Rockwell-automation 1769-OF8V CompactLogix Analog Output Module Manual do Utilizador descarregar pdf (Página 7)

CompactLogix Analog Output Module 7

Rockwell Automation Publication 1769-IN089A-EN-P - March 2011

Assembling the Module

The module can be attached to the controller or an adjacent I/O module before

or after mounting. For mounting instructions, see Panel Mounting on page 9, or

DIN Rail Mounting on page 10. To work with a system that is already mounted,

see Replacing a Single Module within a System

on page 10.

The following procedure shows you how to assemble the Compact I/O system.

1. Disconnect power.

2. Check that the bus lever of the module to be installed is in the unlocked

(fully right) position.

3. Use the upper and lower tongue-and-groove slots (1) to secure the

modules together (or to a controller).

4. Move the module back along the tongue-and-groove slots until the bus

connectors (2) line up with each other.

5. Push the bus lever back slightly to clear the positioning tab (3).

Use your fingers or a small screwdriver.

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Sem comentários

Rockwell-automation 1769-OF8V CompactLogix Analog Output Module Manual do Utilizador Página 7