Rockwell-automation 1769-ADN DeviceNet Modules Installation Instructio Manual do Utilizador descarregar pdf (Página 23)

Rockwell Automation Publication DNET-IN001B-EN-P - January 2012 23

Install a 1756 DeviceNet Communication Module Chapter 1

Apply Chassis Power and

Check Status Indicators

Before you apply power, you must install and connect a ControlLogix chassis and

power supply.

To apply power, follow these steps.

1. Apply chassis power as shown.

2. Check the power supply and status indicators to determine that the power

supply and module are operating properly.

The module status display should cycle through the following states:

TEST - PASS - OK - REV x.x, where x.x is the module’s firmware revision.

Power Supply indicator is green.

OK indicator is red during

self-test, then green.

Module Status Display

I/O

MOD/NET

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 67 68

Sem comentários

Rockwell-automation 1769-ADN DeviceNet Modules Installation Instructio Manual do Utilizador Página 23