Rockwell-automation 1756-ENBT ControlLogix EtherNet/IP Bridge Module I Manual do Utilizador descarregar pdf (Página 13)

ControlLogix EtherNet/IP Bridge Module 13

Publication

1756-IN019C-EN-P - November 2004

Wire the Ethernet Connector

Use an RJ45 connector to connect to the EtherNet/IP network. Wire the

connector according to the following illustration:

For detailed EtherNet/IP connection information, see the EtherNet/IP

Media Planning and Installation Guide, publication number ENET-IN001.

Connect the Module to the EtherNet/IP Network

WARNING

If you connect or disconnect the Ethernet cable

with power applied to this module or any device

on the network, an electrical arc can occur. This

could cause an explosion in hazardous location

installations. Be sure that power is removed or the

area is nonhazardous before proceeding.

RJ 45

8 ------ NC

7 ------ NC

6 ------ RD-

5 ------ NC

4 ------ NC

3 ------ RD+

2 ------ TD-

1 ------ TD+

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Sem comentários

Rockwell-automation 1756-ENBT ControlLogix EtherNet/IP Bridge Module I Manual do Utilizador Página 13