Rockwell-automation 1756-EN2TSC EtherNet/IP Secure Communication User Manual do Utilizador descarregar pdf (Página 19)

Rockwell Automation Publication ENET-UM003B-EN-P - August 2013 19

Get Started Chapter 2

See the next chapters in this manual for different security configurations.

Assign Network Settings

By default, the module is BOOTP enabled.

Choose one of the following methods to assign an IP address.

• Rotary switches on the module (before you install the module)

• Rockwell BOOTP/DHCP utility (available with RSLinx and

Studio 5000 software)

• RSLinx software

• Studio 5000 software

For information on assigning network parameters, see EtherNet/IP Network

Configuration User Manual, publication ENET-UM001

Change Network Settings via the Module Web Page

Choose Administrative Settings > Device Configuration > Network

Configuration. An authenticated user can modify network parameters.

IMPORTANT

Do not simply configure the initial address assigned to the module as a

static IP address. Contact your network administrator for an appropriate

static IP address.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 63 64

Sem comentários

Rockwell-automation 1756-EN2TSC EtherNet/IP Secure Communication User Manual do Utilizador Página 19