Rockwell-automation 1746-NI8 SLC 500 Analog Input Modules User Manual Manual do Utilizador descarregar pdf (Página 38)

4–77

Preliminary Operating Considerations

Publication

17466.8 - April 1997

The module uses a digital low pass filter that provides noise rejection

for the input signals. The digital filter is programmable, allowing

you to select from eight filter frequencies for each channel.

Selecting a low value (i.e., 1 Hz) for the channel filter frequency

provides the best noise rejection for a channel. Selecting a high

value for the channel filter frequency provides lower noise rejection

and faster step response time. See page 4–10 for more information

on noise rejection.

The following table shows the available filter frequencies and step

response for each filter frequency.

Filter

Step Response Time

Filter

Frequency

1% Accuracy

➀

0.1% Accuracy

➀

0.05% Accuracy

➀

1 Hz 730 msec + module update time 1100 msec + module update time 1200 msec + module update time

2 Hz 365 msec + module update time 550 msec + module update time 600 msec + module update time

5 Hz 146 msec + module update time 220 msec + module update time 240 msec + module update time

10 Hz 73 msec + module update time 110 msec + module update time 120 msec + module update time

20 Hz 36.5 msec + module update time 55 msec + module update time 60 msec + module update time

50 Hz 14.5 msec + module update time 22 msec + module update time 24 msec + module update time

75 Hz 10 msec + module update time 15 msec + module update time 18 msec + module update time

no filter 0.5 msec + module update time 0.75 msec + module update time 0.75 msec + module update time

➀

The module accuracy for current inputs is 0.05%, and for voltage inputs is 0.1%.

Channel Step Response

The channel filter frequency determines the channel’s step response.

The step response is time required for the channel data word to reach

a specified percentage of its expected final value. This means that if

an input signal changes faster than the channel step response, a

portion of that signal will be attenuated by the channel filter. The

table above shows the step response for each filter frequency.

Channel Frequency

Channel CutOff Frequency

The channel filter frequency selection determines a channel’s cut-off

frequency, also called the –3 dB frequency. The cut-off frequency is

defined as the point on the input channel frequency response curve

where frequency components of the input signal are passed with

3 dB of attenuation. All frequency components at or below the

cut-off frequency are passed by the digital filter with less than 3 dB

of attenuation. All frequency components above the cut-off

frequency are increasingly attenuated.

Channel Filter Frequency

Selection

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 90 91

Comentários a estes Manuais

Sem comentários

Rockwell-automation 1746-NI8 SLC 500 Analog Input Modules User Manual Manual do Utilizador Página 38

Comentários a estes Manuais

Manuais e produtos relacionados com Equipamento Rockwell-automation 1746-NI8 SLC 500 Analog Input Modules User Manual