Rockwell-automation 1734-AENTR POINT I/O 2 Port EtherNet/IP Adapter Manual do Utilizador descarregar pdf (Página 12)

12 POINT I/O 2 Port Ethernet Adapter

Publication

1734-IN040B-EN-P - December 2009

Refer to publication POINT I/O Ethernet Adapter User Manual,

1734-UM014, for more information.

Replace the Adapter

Use these procedures to install a replacement adapter to an existing

system.

1. Disconnect the Ethernet connector(s) from the adapter.

2. Pull up on the RTB removal handle to remove the terminal

block.

3. Remove the adjacent module from its base.

4. Use a small bladed screwdriver to rotate the DIN rail locking

screw to a vertical position. This releases the locking

mechanism.

5. Lift straight up to remove.

DHCP Enabled and Not Enabled

If DHCP is Then the Adapter

Enabled Asks for an address from a DHCP server. The DHCP server also assigns

other Transport Control Protocol (TCP) parameters

Not enabled Uses the IP address (along with other TCP configurable parameters)

stored in nonvolatile memory

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Sem comentários

Rockwell-automation 1734-AENTR POINT I/O 2 Port EtherNet/IP Adapter Manual do Utilizador Página 12