Rockwell-automation 1492-PLTKIT Plotter Kit - User Manual Manual do Utilizador descarregar pdf (Página 40)

2-24 Initial Setup

3. Place a piece of tape over the engraved “+” on the upper left corner of

the plotter; this is your ideal Zero Point.

4. Select the pen you wish to use for plotting (“No Pen” if you are using a

Sharpie)

5. Press “Plot Zero Point” and watch where on the tape the plotter draws

a “+” in relation to the engraved one on the plotter

6. If the plotted “+” is above or below the engraved one, adjust the Y

setting, if it is to the right or left, adjust the X setting

-Increasing X value: Moves the “+” to the right

-Decreasing X value: Moves the “+” to the left

-Increasing Y value: Moves the “+” up

-Decreasing Y value: Moves the “+” down

Note: Suggested increment of change: 5.0

7. Continue adjusting the settings until the Zero points match, then reprint

the test card and determine if the calibration is correct.

Adjusting Marker Type

If calibrating the Zero Point does not seem to be effective on a single card

type, go to File→ Print→ Calibration and select “Adjust Marker Type” to





TIP

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 61 62

Sem comentários

Rockwell-automation 1492-PLTKIT Plotter Kit - User Manual Manual do Utilizador Página 40