Rockwell-automation 1440-TBS-J XM Dynamic Measurement Module Terminal Manual do Utilizador descarregar pdf (Página 15)

XM Dynamic Measurement Module Terminal Base 15

Publication

ICM-IN003D-EN-P - March 2013

Panel/Wall Mounting

Installation on a wall or panel consists of:

• laying out the drilling points on the wall or panel.

• drilling the pilot holes for the mounting screws.

• installing the terminal base units and securing them to the wall or

panel.

Follow these steps to install the terminal base on a wall or panel.

1. Lay out the required points on the wall/panel as shown in the drilling

dimension drawing below.

Maintain at least 25.4 mm (1.0 in.) air space around your XM system

installation.

2. Drill the necessary holes for the #6 self-tapping mounting screws.

3. Secure the terminal base unit using two #6 self-tapping screws.

4. To install another terminal base unit, retract the side connector into

the base unit; make certain it is fully retracted.

40.10

[1.577]

35.51

[1.398]

23.50

[.925]

94.01

[3.701]

Screw hole for

panel/wall

mounting.

Grounding

screw hole

for panel/

wall

mounting.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Sem comentários

Rockwell-automation 1440-TBS-J XM Dynamic Measurement Module Terminal Manual do Utilizador Página 15