Rockwell-automation 1336S PLUS II Analog Interface Inst. Manual do Utilizador descarregar pdf

Instructions

This publication will guide you through installation (including

mounting and setup) of the 1336

PLUS II Analog Interface Option

Board(s).

Option Board Installation

1. Remove and lock-out all incoming power to the drive. Remove/

open the drive cover.

2. Using the following table, verify that you have the correct option

board and note the slot designation for installation.

ATTENTION: This drive contains ESD (Electrostatic

Discharge) sensitive parts and assemblies. Static control

precautions are required when installing, testing, servicing

or repairing this assembly. Component damage may result

if ESD control procedures are not followed. If you are not

familiar with static control procedures, reference A-B

publication 8000-4.5.2, “Guarding Against Electrostatic

Damage” or anyotherapplicableESDprotectionhandbook.

ATTENTION: To avoid a shock hazard, assure that all

power to the drive has been removed before proceeding. In

addition, verify that the DC bus has discharged by

measuring across the “+DC” and “–DC” terminals of TB1

with a voltmeter. The voltage should be 0.0VDC.

Catalog

Number Description

Must be

Installed in . . .

1336F-LA2 Two Isolated Conﬁgurable Inputs

Slot A

1336F-LA6 One Isolated Bi-polar Input (

10V or

20mA)

and One Isolated Thermistor Input

1336F-LA7 One Isolated Bi-polar Input (

10V or

20mA)

and One Isolated Conﬁgurable Input

1336F-LA1 Single-ended, Non-isolated Conﬁgurable

(including Pot) Input & 2 Single-ended, Non-

isolated Outputs (1 - Conﬁgurable, 1 - 20mA)

Slot B

1336F-LA3 Two Isolated Conﬁgurable Outputs

1336F-LA4 One Isolated Conﬁgurable Input & Output

1336F-LA5 Isolated Pulse Input, Non-isolated Pulse Output

& Single-ended, Non-isolated Conﬁgurable

Output

1336 PLUS II Analog Interface

Option Board Installation

1 2 3 4

Resumo do Conteúdo

Página 1 - Option Board Installation

InstructionsThis publication will guide you through installation (includingmounting and setup) of the 1336PLUS II Analog Interface OptionBoard(s).Opti

Página 2 - A1 - A4 Frame Drives

2 1336 PLUS II Analog Interface Option Board Installation3. Set the DIP switches for desired conﬁguration.Each board will have one or two DIP switches

Página 3 - B Frame & Up Drives

1336 PLUS II Analog Interface Option Board Installation 3B Frame & Up DrivesA. Locate the appropriate slot for installation. Remove anyjumpers (fr

Página 4 - I/O Speciﬁcations

4 1336 PLUS II Analog Interface Option Board InstallationI/O SpeciﬁcationsSpeciﬁcations for the various inputs and outputs are provided below.1Use TB2