Rockwell-automation Logix5000 Controllers Function Block Diagram Progr Manual do Utilizador descarregar pdf (Página 28)

Chapter 1 Program a Function Block Diagram

Enter a value in the tag of a block

Complete these steps to assign a value to a parameter when on wire connects to its

pin.

1. In the block, click Properties

2. On the Parameters tab, in the Value box of the desired parameter, type the

value.

3. Click OK.

Use an output wire connector (OCON) or input wire connector (ICON) to

transfer data between sheets or in complex wiring situations.

Add an OCON

1. Add an OCON and place it near the output pin that supplies the value.

2. Wire the OCON to the output pin.

3. Double-click the operand area of the OCON.

4. In the box, type a name that identifies the connector and press Enter.

Add an ICON

1. Add an ICON and place it near the input pin that gets the value from the

corresponding OCON.

Connect blocks with an

OCON and ICON

28 Rockwell Automation Publication 1756-PM009E-EN-P - October 2014

1 2 ... 23 24 25 26 27 28 29 30 31 32 33

Sem comentários

Rockwell-automation Logix5000 Controllers Function Block Diagram Progr Manual do Utilizador Página 28